Important:
US Bound shipments are only available via postal services.
Note: We are suspending all US shipments on Oct 15th.
The next round of CBP tariff changes and processing paper work requirements are not reasonable for low value products. They are coming into force on Oct 22nd.
We do not depend on US sales and the additional costs of providing extensive CBP paper work for every product is more than we are willing to accept at the moment.

Gelidus Research RATGDO Thread Board USB-C

$46.00

The Gelidus Research RATGDO Board provisions.

- Powerful RISC-V ESP32-C6 160Mhz 4MB Flash, BLE, IEEE 802.14.5 (Zigbee/Thread) and WiFi6 module!
- 8 Pin Quick connect.
- Direct USB-C programming interface.
- 0.5 Meters of 3 conductor 22 AWG bell wire.
- 3D printed protective enclosure.
- External Antenna.
- USB-C power and programing port
- Status LED

Options

Power

Clear

SKU: GRGDO1-KIT-3-USB-C-1 Category: Garage Door Opener

Description

GRGDO1-KIT-3-USB-C:

Gelidus Research RATGDO Thread board:

Note: This SKU requires a USB-C power source, it does not include a USB cable and Power Pack, we have an optional UL listed wall wart and cable available. UL USB-C

- RATGDO compatible hardware.
- ESPHome SecplusGDO firmware is preloaded with the captive WEB portal.
- This board only runs SecplusGDO firmware due to the IDF requirement in ESPHome.
- Works with ESPHome Thread or Wifi Networking.
- AC Model not available at this time.

Note: SecplusGDO does not support dry contact doors at this time.

GRGDO1 RATGDO Board Hardware:

- 60 x 60 mm PCB
- 5 Pin Aux1 port header (GND, 3.3v GPIO10, GPIO11,GPIO15)
- 5 Pin Aux2 port header (GND, 3.3v GPIO7,GPIO19, 5v)
- Powerful RISC-V ESP32-C6 160Mhz 4MB Flash, BLE, IEEE 802.14.5 (Zigbee/Thread) and WiFi6 module!
- 8 Pin Quick connect.
- Direct USB-C programming interface.
- 50cm of 3 conductor 22 AWG bell wire.
- 3D printed protective enclosure.
- External Antenna.

Software:

This Gelidus Research RATGDO is designed to run on ESPHome frameworks. ESPHome integration with Home Assistant (HA) is ideal for providing a rich user interface. Adding the GRGDOv3 to ESPHome and HA is easy using the preinstalled captive portal. Using any tablet or phone etc. that identifies a captive portal. You can link up the module without any serial firmware programming hassle’s. Once connected to your WIFI network it’s strait forward with HA integration.

Note: While this hardware is Zigbee capable, the available software to support it is not mature enough for production.

Install Guide: https://www.gelidus.ca/grgdov3-setup-guide/

Case STL files: grgdo1.case.bot.usb.v2 grgdo1.case.top.usb.v2